Table of Contents
Advertisement
During processing of banknotes, Pcs and Value will show on the LCD display screen when device is
in discriminating modes (MIX / SINGLE / SORT etc.).
When device is set to COUNT Mode, only Qty (Pcs) will be displayed on the LCD screen.
As default, USD currency shows on the very top left corner
of the LCD display. USD currency stands for US Dollar and
less restrictive as to banknote reading criteria). Operator has
the option to select USA version of US Currency Software
which is more restrictive as to banknote reading criteria (i.e.
stop at very worn out bills) and may generate more non-read
bills.
If Operator decides to switch to another installed currencies, such as Canadian (CAD), use
navigation down arrow ▼on the right side of the control panel
to change to other currency and press
key to save the selection. Newly selected currency will then
be displayed on the very top left corner of the LCD display
screen.
(AUTO) Currency:
Selection of AUTO currency mode means,
passes through and successfully read whether it is US currency or Canadian currency or any other
currency-type that operator may have purchased and installed onto this device. Other than
standardized currency-type, all other currency-type will then be rejected, means, device will stop
for removal by operator.
Selection of AUTO currency mode is same as described above.
MULTI-Currency:
Currency Discriminator device has capability of processing mixture of world-currencies in a
MIB-1
single-pass (for example, US and Canada). Once selected, MULTI will be shown at the very left
corner of the display screen and device is ready to process mixture of multiple currency-types in a
single pass. During counting, device will not be showing the value of the counted currency since
multiple-currencies are being processed, however, operator would be able to see processed quantity
and value for each currency by pressing
Batch Counting
The MIB-1 device allows users to set counting of banknotes by a
batch number from 1 - 200 (quantity) or turn it off. Pre-set batch can
apply to all counting modes except SINGLE or SORT mode as
described below. To turn on BATCH, press
on the control panel. Device will display batch setting screen where
operator can turn ON or OFF batching function by using navigation ►
Page | 9
START/STOP
device will standardize the first currency-type
MIB-1
key on the left side of the control panel.
BATCH /3 Key
Advertisement
Table of Contents
