Power On / Off; Placing Banknotes - Amrotec MIB-1 Operator's Manual

 Power On / Off
 Placing Banknotes
To operate the currency Discriminator device efficiently, please follow the below instructions:
 Avoid counting wet, excessively dirty, or spoiled banknotes.
 Check for foreign object mixed with banknotes, i.e.: paper chips, rubber bands, clips, dust, etc.
which will jam the bill path or even may damage the sensors.
 Prior counting, remove severely folded or curled banknotes from the stack of banknotes to be
counted.
 Align all corners and edges of banknotes to avoid excessive rejection of banknotes to reject stacker
for recognition errors.
 Put all banknotes in the middle of the note hopper and adjust the hopper guide for better alignment
and feeding of banknotes.
Page | 7
To power on :
MIB-1
 Plug in the A/C power cord to the Power Socket.
 Press the Power Switch button (I/O) on the rear side of
MIB-1.
 After System initialization stage is completed,
enters into main display screen and ready.
To power off
MIB-1:
 Prior powering off, make sure that all counting results are
saved to memory.
 Press the power switch button (O/I) to turn off the device.
MIB-1