Table of Contents
Advertisement
key on the right or change default pre-set batch from 100 to any number up to 200 by using numeric 10-keys
pad on the control panel.
Normal batch setting (using of numeric 10-keys)
Press ► key to reach to Present batch No: 100 and use numeric 10-keys on the control panel to
change to desire batch number up to 200 (maximum Stacker capacity).
The set batch will be shown on the right top of the LCD
display.
Place banknotes on the note hopper to start counting (Auto
Start mode) or press
counting.
To cancel the batch, press
turn batch off.
Denomination Batch Setting (DB):
Denomination associated Pre-set Batch function [DB] is
available with 'SINGLE' and 'SORT' counting mode as well
normal batch setting. Operators usually prefer to set a specific batch
number for each denomination while they are separating banknotes
using SINGLE or SORT mode (See below and Page 22 in
additional). Therefore, MIB-1 provides denomination batching
options for operators and operators can activate or deactivate [DB]
in SINGLE mode or SORT mode by pressing
appear on the TOP right corner of the display screen. By default,
100 is set as batch qty for all banknote denomination in DB setting which operator can change to any
numbers up to 200.
How to set DB batching:
Press
key MENU 4. Setting DB menu item to enter into DB setting.
Page | 10
to start (Manual count mode)
key followed by ► key to
key. DB will
How to set DB batching:
Press
key MENU 4. Setting DB menu item to
enter into DB setting.
Once in 4. Setting DB, press
into the setting screen.
Arrow will point to the first denomination, here $ 100 and Value
is set 100. To change the default 100 value, use 10-keys on the
left side of the control panel.
To move to next denomination, press left navigation arrow [◄]
and then, use 10-keys pad to select your desire batch number.
Start/ Stop key to enter
Advertisement
Table of Contents
