Installation - Husqvarna AUTOMOWER 305 Operator's Manual

• The product may only be operated, maintained and
repaired by persons that are fully conversant with
its special characteristics and safety regulations.
Please read the Operator's Manual carefully and
make sure you understand the instructions before
using the product.
• It is not permitted to modify the original design
of the product. All modifications are made at your
own risk.
• Check that there are no foreign objects such as
stones, branches, tools or toys on the lawn. If
the blades hit foreign objects the blades can be
damaged. Always switch off the product with the
ON/OFF button before clearing a blockage. Inspect
the product for damage before staring the product
again.
• If the product starts to vibrate abnormally. Always
switch off the product with the ON/OFF button
and inspect for damage before staring the product
again.
• Start the product according to the instructions.
When the product is switched on, make sure to
keep your hands and feet away from the rotating
blades. Never put your hands and feet under the
product.
• Never touch moving hazardous parts, such as the
blade disc, before it has come to a complete stop.
• Never lift up the product or carry it around when it
is switched on.
• Do not let persons who do not know how the
product works and behaves use it.
• The product must never be allowed to collide with
persons or other living creatures. If a person or
3.1 Introduction - Installation
WARNING:
safety chapter before you install the product.
1508 - 010 - 17.01.2022

3 Installation

Read and understand the
other living creature comes in the product's way it
shall be stopped immediately. Refer to
product on page 17 .
• Do not put anything on top of the product or its
charging station.
• Do not allow the product to be used with a
defective guard, blade disc or body. Neither should
it be used with defective blades, screws, nuts or
cables. Never connect a damaged cable, or touch
a damaged cable before it is disconnected from
the supply.
• Do not use the product if the ON/OFF button and
STOP button does not work.
• Always switch off the product using the ON/OFF
button when the product is not in use. The product
can only start when the product has been switched
on with the ON/OFF button and the correct PIN
code has been entered.
• Husqvarna does not guarantee full compatibility
between the product and other types of
wireless systems such as remote controls, radio
transmitters, hearing loops, underground electric
animal fencing or similar.
• Metal objects in the ground (for example
reinforced concrete or anti-mole nets) can result
in a stoppage. The metal objects can cause
interference with the loop signal which then can
lead to a stoppage.
• Operation and storage temperature range is 0-50
°C / 32-122 °F. Temperature range for charging is
0-45 °C / 32-113 °F. Too high temperatures might
cause damage to the product.
2.3 Battery safety
WARNING:
explode or cause fire if disassembled,
short-circuited, exposed to water, fire, or
high temperatures. Handle carefully, do not
dismantle, open the battery or use any
type of electrical/mechanical abuse. Avoid
storage in direct sunlight.
For more information about the battery, refer to
on page 19
CAUTION:
Use original spare parts and
installation material.
To stop the
Lithium-ion batteries can
Battery
Installation - 9