Operation - Husqvarna AUTOMOWER 305 Operator's Manual

3. An e-mail is sent to the registered e-mail address.
Follow the instructions in the e-mail in less than 24
hours to validate your account.
4. Log in to your Husqvarna account in the
®
Automower Connect app.
3.8.2 To pair Automower
and the product
®
Automower Connect@Home function with Bluetooth
communication is included in Automower
Mark II / 315 Mark II. This means that the mobile device
can communicate with the product while you are in
®
Bluetooth communication range.
To pair Automower
1. Do steps 1–3 in
Connect@Home and the product on page 16 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Connect@Home > Pairing > New pairing .
3. Follow the instructions in the Automower
app.
3.8.3 To pair Automower
product
®
Bluetooth communication and the Automower
Connect kit for cellular communication is included in
Automower ® 405X/415X.
4.1 To use the ON/OFF button
WARNING:
safety chapter before you use the product.
WARNING:
away from the rotating blades. Do not put
your hands or feet near or below the product
when the product is set to ON.
WARNING:
when persons, especially children, or
animals are in the work area.
• Push the ON/OFF button for 3 seconds to set the
product to ON. Make sure that the LED indicator
comes on.
• The product is ON and in power save mode if the
LED indicator flashes. Push the ON/OFF button for
3 seconds to set the product to ON.

16 - Operation

®
Connect@Home
®
®
305 / 310
®
Accessories >
® Connect
®
Connect and the
®
4 Operation
Read and understand the
Keep your hands and feet
Do not use the product
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 14 .
2. Use the arrow buttons and the OK button to
move through the menu structure
®
Automower Connect > Pairing > New pairing .
3. Follow the instructions in the Automower
app.
3.9 Download firmware over the air
FOTA (Firmware over the air)
FOTA (Firmware over the air) is included in Automower
405X/415X. This function automatically downloads new
firmware to the product. When a new firmware is
available, a notification shows in the app where you can
select to install the new firmware. In the factory setting
this function is enabled.
• Push the ON/OFF button for 3 seconds to set the
product to OFF. Make sure that the LED indicator
goes out.
4.2 To start the product
1. Push the STOP button to open the hatch.
2. Push the ON/OFF button for 3 seconds. The
display is lit up.
3. Enter the PIN code.
4. Push the START button.
5. Select an operating mode. Refer to
modes - Start on page 17 .
Accessories >
® Connect
®
Operating
1508 - 010 - 17.01.2022