Maintenance & Lubrication; Maintenance Schedule; Cutting Edge Maintenance; Gear Box Maintenance - Bercomac 700980-1BER Owner's Manual

Maintenance & Lubrication
WARNING
To avoid serious injury or death :
•
Always follow all safety precautions in the important
safety information section of this manual.
•
Follow all instructions and safety precautions in your
vehicle manual and any other related accessory
manual.
•
Use jack and support blocks to support equipment
when required. Carefully release pressure from
equipment with stored energy.
•
Replace parts on this accessory with genuine parts
only.
•
Never work or walk under the accessory unless
securely blocked. Otherwise accessory can fall.
•
Never allow untrained personnel to service machine.

Maintenance schedule

Frequency of
maintenance
at each:
8 hours Make sure that the bolts are still
tightened correctly and that the skids and
scraper bar are not too worn
10 hours - Grease the telescopic part of the drive
shaft every 10 hours using multipurpose
grease (1zerk)
- Oil chute base
- Greasable bearings
- Grease every 10 hours of use the cross of
the drive shaft with multipurpose grease
(2 zerk)
After first Gearbox change oil
100hours
1 year or Gearbox change oil
600 hour,
whichever
comes first
Year Check the oil level of the gearbox

Cutting edge maintenance

Check the scraper bar wear from time to time to make sure
Maintenance & Lubrication
Element to do:
you do not use the bottom of the snowblower frame. The
scraper bar is reversible.
Cutting edge maintenance
Check the scraper bar wear from time to time to make sure
you do not use the bottom of the snowblower frame. The
scraper bar is reversible.

Gear box Maintenance

Change the oil after the first 100 hours of use. Then change
after every 600 hours or each year.
The type of oil used: SAE90.EP
The gearbox should contain 1.2 liters of oil.

Greaseable bearings

Grease every 10 hours of use with multipurpose grease (qty:
as needed).

Shear bolt sprocket hub

Lubricate every 10 hours with multipurpose grease (qty:
2 pumps).

Chain

Lubricate when required with commercial chain lubricant
(qty: as needed).
22