Table of Contents
Advertisement
Assembly & initial set-up
Accessory assembly
Installation of the kits for the rotation
and the deflection of the chute:
Installation of the hydraulic chute rotation kit
#701011-1
:
See the instructions supplied with the kit.
Installation of the manual chute rotation kit
#701029 :
See the instructions supplied with the kit.
Installation of the electric chute rotation and
deflection kit #701036 :
See the instructions supplied with the kit.
Installation of the electric chute deflection kit
#700666-2 :
See the instructions supplied with the kit.
Installation of the PTO drive shaft:
Remove the guard:
Remove the guard (item 1) by removing the hair pin
(item 2). Install the drive shaft by following the
instructions mentioned below.
After installing the drive shaft, put the guard back in
place and secure it with the hair pin.
PTO drive shaft installation
Install the PTO driveshaft (item 1) on the snowblower
input shaft (item 2). Then install the two bolts M12 x 1.25
x 70 Grade 8.8 (item 3) and nuts (item 4).
NOTE: If the length of the PTO driveshaft has not been
validated, secure with the nuts only after this validation.
PTO drive shaft chain installation
Install the PTO driveshaft chain (item 5) on the
snowblower. If this is the first time you install the
snowblower on the tractor follow the instruction of
validation of the PTO drive shaft
Validation of the PTO drive shaft (if
first installation):
The length of the PTO drive shaft must be adjusted in
8
Advertisement
Table of Contents
