Table of Contents
Advertisement
CONFIGURING PROGRAM FUNCTION KEYS
1
The Programmable Function keys are [PF], [MR], [VFO],
2
and [CALL] located on the face of the microphone. If you
prefer, you can change the default functions assigned to
3
these keys.
4
Programmable Function Key
5
[PF]
6
[MR]
7
[VFO]
8
[CALL]
9
To assign a front panel key function:
10
1 Press one of the following key combinations depending
on which key you want to re-program:
11
Mic [PF]+ POWER ON ("PF 1" appears)
12
Mic [MR]+ POWER ON ("PF 2" appears)
13
Mic [VFO]+ POWER ON ("PF 3" appears)
14
Mic [CALL]+ POWER ON ("PF 4" appears)
15
2 Press the key or key combination on the front panel that
you want to assign.
16
17
18
19
20
21
72
Default Function
TX Band Select
Memory Recall
VFO Select
Call Channel Select
•
The following types of front panel key functions can be
assigned:
[KEY]
[KEY] (1 s)
[F], [KEY]
•
The following types of front panel key functions cannot be
assigned:
[KEY]+ POWER ON
[F]
[F] + Mic [KEY]
PWR switch
VOL control
SQL control
•
The front panel key will still function normally after
"copying" its function to a Programmable Function key.
•
To restore the default functions shown in the table above,
do a Full Reset {page 35}.
Note:
If the LOCK switch located on the rear of the microphone is ON,
you cannot re-program the Programmable Function keys.
Pressing the PTT switch in step 2 assigns the VFO/MR Switch
function.
[F] (1 s) , [KEY]
[F] (1 s)
Tuning control
Advertisement
Table of Contents
