Table of Contents
Advertisement
Fixed Station Operation
1
In order to use this transceiver for fixed station
2
operation, you will need a separate 13.8 V DC power
supply that must be purchased separately. The
3
recommended current capacity of your power supply is
12 A.
4
1 Connect the DC power cable to the regulated DC
5
power supply and check that polarities are correct
6
(Red: positive, Black: negative).
7
•
DO NOT directly connect the transceiver to an
AC outlet!
8
•
Use the supplied DC power cable to connect the
9
transceiver to a regulated power supply.
10
• Do not substitute a cable with smaller gauge
wires.
11
Fuse holder
12
13
Red (+)
14
Black (–)
15
16
17
18
19
20
21
4
Regulated DC power
supply
To AC outlet
2 Connect the transceiver's DC power connector to
the connector on the DC power cable.
•
Press the connectors firmly together until the locking
tab clicks.
Press
firmly.
Note:
For your transceiver to fully exhibit its performance capabilities,
the following optional power supply is recommended:
PS-33 (20.5 A, 25% duty cycle).
Before connecting the DC power supply to the transceiver, be
sure to switch the transceiver and the DC power supply OFF.
Do not plug the DC power supply into an AC outlet until you
make all connections.
Fuse holder
Advertisement
Table of Contents
