Table of Contents
Advertisement
Using Visual Scan
1
1 Select the desired band.
2
2 Turn the Tuning control, or press Mic [UP]/[DWN],
to select the operating frequency.
3
•
This frequency will also be used as the center
4
frequency.
5
3 Press [F] , [VISUAL] to start Visual Scan.
6
•
To halt Scan, press [PAUSE] . "P" appears.
Press [PAUSE] again to resume.
7
8
9
10
11
4 To change the operating frequency, turn the Tuning
12
control or press Mic [UP]/[DWN].
13
•
The displayed frequency changes and the cursor
moves.
14
•
Press [SET] to use the changed operating frequency
15
as the center frequency.
•
Press [RESET] to restore the previous operating
16
frequency.
17
5 To quit Visual Scan, press [OFF] .
18
19
20
21
42
Note:
If you start Visual Scan in Memory Recall mode, the memory channel
frequencies will be scanned.
If you start Visual Scan after recalling the Call channel, the call
channel frequency will be used as the center frequency.
Visual Scan stops while transmitting.
Starting Visual Scan switches Automatic Band Change OFF.
If you start Visual Scan in one of the following conditions, you cannot
receive in the current operating frequency. To use this frequency,
press [PAUSE] to halt Scan.
•
Memory Recall or Call Channel mode
•
The VHF band, VFO mode, and a frequency in the range
118 MHz to 136 MHz were selected.
Depending on conditions, Visual Scan and the conventional S-meter
may indicate different signal strength levels.
Advertisement
Table of Contents
