Kenwood TM-V7A Instruction Manual page 79

To assign a function unavailable using the front panel keys:
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 16 (Microphone).
CALL CALL
3 Press [ s s s s s ] , then select Item No. 2 (PF 1) to No. 5 (PF 4).
CALL CALL
2
4 Press [SET] to select the desired function.
Each time you press [SET] , the selection changes as
•
shown below:
User Setting Monitor
(PF 1 only) 1750 Hz Tone (TM-V7E only)
5 Press [MNU] again to exit Menu mode.
PWR PWR
VOL SQL
PWR PWR
VOL SQL
1
Enter Voice PWR switch
User Setting:
Selects the front panel key function you assigned
{page 72}.
Monitor:
Makes the squelch open and allows you to monitor activity
on the current frequency. This function is useful when
adjusting the volume or when receiving weak signals.
• Pressing the re-programmed Mic key toggles Monitor ON or
OFF.
• Scan will not function if Monitor is ON (squelch open).
Enter:
Allows you to enter digits from the MC-53DM microphone.
Refer to KEYPAD DIRECT ENTRY
"
Voice:
Activates or deactivates the function that announces the
current Control band frequency using beeps of different
frequencies. Press any key to stop beeps.
PWR switch:
Turns the transceiver ON or OFF. This function can be
assigned only to PF 1.
1750 Hz Tone (TM-V7E only):
Activates the Tone function and transmits a 1750 Hz tone
while you are holding down the re-programmed Mic key.
You need not press Mic [PTT].
• You can also use Transmit Hold to continuously send a
1750 Hz tone for 2 seconds after releasing the
re-programmed Mic key. To activate this function, access item
No. 3 (1750 Hz Timer) in Menu No. 5 (Repeater).
{page 74}.
"
73
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21