Gliderol Roll.in.One Installation Instructions Manual page 9

3. 2 beeps will signal for successful coding and a transmitter already in memory
4. Unit will automatically exit the setup
Single Button Configuration: Any one of the three buttons in the transmitter can be used to control all three
functions Stop/Open/Close. Useful when one transmitter can operate more than one door and a maximum
of three doors.
Three Button Configuration: Each buttons in the transmitter can be used to control
individual functions like functions Stop/Open/Close of the same door.
3.0 Transmitter Code Erase
1. Press and hold [C] for 8 seconds, [CODE] will light
2. While LED diminishes, ALL codes have been erased
4.0 Limit Setting – By Controller
1. Press and hold [ S] button, release finger while the red light turns from [F] to [L]
2. Press [S] again, when the light of [SEL/ADJ] turns RED or GREEN, select the desire drive handing
RED indicates Left Hand Drive
GREEN indicates Right Hand Drive
3. Release finger after selecting the right mode with 3 beeps after 4~5 seconds, and then light of [SEL/ADJ] turns
green and starts blinking
4. Proceed to setup the TOP limit, by pressing [OPEN] button on transmitter, and confirm TOP limit position by
pressing [STOP] button. 2 beeps will signal for successful programming.
**While setting the TOP limit the [SEL/ADJ] light will turn green and starts blink.
ROLL.in.One Installation Instructions & Owner's Manual
[KEY1]
Stop/Open/Close
[KEY1] STOP
[KEY2] OPEN
[KEY3] CLOSE
Page 9