Gliderol Roll.in.One Installation Instructions Manual page 12

Owner's Manual for the
Roll.in.One Automatic Roller Door Operator
CONGRATULATIONS! On the purchase of your Roll.in.One Automatic Roller Door Opener
INDEX
Door Operation
Manual Operation
Obstruction Detection
Vacation Mode
Automatic Closing
Courtesy Light
Audible Buzzer
Rolling Code Security
Door Operation
A roller door equipped with a Roll.in.One opener may be
operated by using the handheld Transmitter.
Momentary activation of the above method will activate
the door to open or close.
! WARNING - Ensure that the Centre Lift Lock is not
engaged when the Drive Unit is in the automatic
position.
Manual Operation
In the case of a power failure the Roll.in.One opener has
an easily accessible manual release chord. Pulling the
manual release chord once will set the door for manual
operation and pulling it again will set the door for
electric operation.
Obstruction Detection
During an open cycle if an obstruction is detected, the
door will stop. During a closing cycle if an obstruction is
detected, the door will reverse to the open position. The
sensitivity or the amount force required to cause
obstruction detection is fully adjustable (refer to 5.0
Force setting on page-10) for force adjustment.
Vacation Mode
When the door is not used for a long time or during
vacation it can be set to vacation mode for security
purposes. To activate & deactivate vacation mode refer
to 8.0 on page-10.
Automatic Closing
The Roll.in.One opener can be programmed to
automatically close from 10 to 30 seconds after the door
has been opened (refer to 6.0 on page-10) to activate
and deactivate Auto- Close function.
Courtesy Light
An internal courtesy LED light is housed within the
control box enclosure. This is activated during an open
or close cycle and will stay illuminated for approximately
60 seconds.
ROLL.in.One Installation Instructions & Owner's Manual
Page
13 Key Ring Handset
13 Wireless Wall Button Switch
13 Photo Electric Sensor
13 Trouble shooting table
13 Technical Specifications
13 Warranty
13 Warranty Form
13 Sales & Service
Audible Buzzer
The Roll.in.One has an internal Piezo Siren that will beep
momentarily each time the door is activated by factory
default it will be enabled.
This function can be disabled if required to disable
remove jumper 'j9' next to buzzer 'Bz1' refer to PCB
index diagram on page-7.
Rolling Code Security
The transmitter and receiver incorporate the latest state
of the art encryption technology.
This allows the coded transmission to change after each
operation with literally billions of unique combinations.
Each Roll.in.One opener has the facility to store up to 15
individual handsets.
Key Ring Handset
The hand transmitter is manufactured using the latest
surface mount technology and incorporates 3 functional
buttons. This enables the user to remotely control up to
3 separate operators from the one handset or configure
each button to operate OPEN / CLOSE / STOP functions.
Wireless wall Button Switch
A wireless wall button, single or three buttons can be
mounted on the wall to operate the door.
Photo-electric sensor
The Roll.in.One roller door opener includes an interface
for the connection of a photo-beam sensor. When fitted,
during door closing if the photo sensor has been
triggered the door will auto reverse with continuous
beep sound. The Photo-beam sensor can be supplied as
an accessory option. (Refer to 10.0 on page 12 for wiring
diagram)
! WARNING - In some countries it is a legal requirement
to fit Photo-cell sensors. Please check with your local
distributor
Page
13
13
13
14
15
16-17
18
18
Page 12