Gliderol Roll.in.One Installation Instructions Manual page 8

Operating Panel
1. [C] button - coding button
2. [S] button
Press and hold < 0.5 second - single button operation (when limit is already set)
Press and hold > 0.5 second and <1.5 seconds - no action
Press and hold > 1.5 seconds - enter functional setting
1.0 Transmitter Coding – By Controller
3. Press[C] button once
4. [CODE] will light with 3 beeps
5. Press the desired operation key on transmitter
6. LED will diminish to signal successful programming
1.1 Transmitter Coding – By Transmitter
1. Using an already programmed transmitter, press and hold OPEN & STOP keys
simultaneously for 2 seconds
2. Unit will beep three times to signal for Learn Mode
3. Press the desired operation key on the new transmitter
4. A beep will signal for successful coding. Two beeps signal for a transmitter
already in memory
5. Unit will automatically exit the setup after 3 seconds
2.0 Transmitter Key Setting
1. Press and hold [S], release finger while the red light turns from [F] to [K]
2. Press [S] again, when the light of [SEL/ADJ] turns RED or GREEN:
RED indicates 3 button operation
GREEN indicates single button operation
ROLL.in.One Installation Instructions & Owner's Manual
Fig: 10
Fig: 11
[KEY1] STOP
[KEY2] OPEN
[KEY3] CLOSE
Page 8