Troubleshooting - Gliderol Roll.in.One Installation Instructions Manual

Automatic roller door opener
Table of Contents

Advertisement

Trouble Shooting
Before you call your local Gliderol agent please check the following Fault Table
SYMPTOM
1. Door does not operate.
2. Drive motor operates but door does not move.
3. Door auto-reverses after closing fully.
4. Door stalls at fully open position and continues
to try to open the door if button is pressed again.
5. Door open and closed positions incorrect
(Stop short)
6. Courtesy light comes on but door does not move
7. Handset range diminishes.
8. Handset does not open the door.
9. Door auto-reverses before it is closed.
10. Door stops during opening.
11. Door does not operate and the courtesy lamp
is not on.
ROLL.in.One Installation Instructions & Owner's Manual
ACTION
 Check electrical supply to unit.
 Press handset and/or bell press button again.
 Manual release may be engaged, pull the manual release chord
once to put the drive unit back to electric operation
 The door should not stop by striking the ground; reset the door
travel limits by limit learning
 The door has lost its limits, it should not stop by striking the top
guide stop; reset the door travel limits by limit learning
 The door has lost its limits (top limit and bottom limit). Reset the
door travel limits by limit learning
 Manual release may be engaged, pull the manual release chord
once to put the drive unit back to electric operation
 Replace handset battery after 12 months.
 Check position of antenna on unit to ensure it is relatively straight
and not adjacent to the power cord.
 Replace handset battery after 6-12 months.
 Check position of antenna on unit to ensure it is relatively straight
and not adjacent to the power cord.
 Check that the handset has been programmed to the door
 Check the force sensitivity setting and readjust
Check the door is not jammed in tracks.
 Check the force sensitivity setting and readjust
Check the door is not jammed in tracks.
 Check power is switched on.
 Check the fuse on circuit board and replace.
 Check the door is not jammed in tracks.
.
(page 10)
(page 10)
.
(page 10)
.
(page 11)
.
(page 11)
.
(page 8)
Page 13

Advertisement

Table of Contents
loading

Table of Contents