Gliderol Roll.in.One Installation Instructions Manual page 5

h) Replace right hand side wall mount bracket (Fig 4)
Fig: 5
Fig: 4
i) Carefully remove the support from the door and rest spindle on the wall mount bracket
j) Locate the Drive unit on the bracket and fit 'U' bolt provided in the fitting kit. Tighten the 'U' bolt with two nuts
provided (Fig 5).
k) Fit Anti coning collar to the opposite end of the door to avoid sideways movement of the drum wheel.
Alternate Method: On smaller size doors the Roll.in.One unit may be installed without removing and replacing the
bracket. After step (d) carefully lift the roller door from the bracket enabling Roll.in.One unit to slide on to the
spindle of the door. Ensuring the unit's fork is properly engaged with the spoke of drum wheel carefully rest the
door on the spindle and follow consecutive steps from (j).
ROLL.in.One Installation Instructions & Owner's Manual Page 5