Table of Contents
Advertisement
7.0 LED Control
Under 3 Keys transmitter mode, the LED can be switched on and off using the STOP key.
8.0 Vacation Mode
Transmitter signal can be locked out by pressing STOP & CLOSE keys simultaneously and holding it for 3 seconds
on the transmitter. To deactivate, press the same keys again and hold it for 3 seconds.
9.0 Key Ring Transmitter
Plastic Strip
Battery Type 3V CR2016x2 (Lithium Cell)
To replace batteries:
1. Remove the screw on the back case.
2. Replace the old batteries with new ones (3V CR2016x2) and ensure plastic strip remain intact in clip.
3.
Locate back of case and secure with screw.
10.0 Photo Sensor Connection Diagram
GND-Black
COM-Brown
N,C-Yellow
N,O-White
12V-Red
ROLL.in.One Installation Instructions & Owner's Manual
Page 11
Advertisement
Table of Contents
