Operating A Dbs Using The Remote Control; Setting The Manufacturer Code - JVC CA-NXF30 Instructions Manual

Using the remote control for the TV
operation
Before the TV operation, select the remote control
mode for the TV.
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1
Press [TV].
2
Operate the remote control by
pointing it at the TV.
.
Remote
Usage
control button
[TV ] Turns on/off the TV.
F
Changes between the TV and
[TV/VIDEO]
video input.
[CH +/ ] Changes channels.
–
[TV VOL +/ ] Adjusts volume.
–
Number Selects the channels.
buttons (1-9, 0,
100+)
Changes between the previously
[TV RETURN] selected channel and the current
channel.
NOTE
• When the remote control mode selector is slid to
the lowest position and [TV] is pressed, some
buttons may not work.
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
Operating a DBS using the
remote control

Setting the manufacturer code

■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1
Press [DBS].
2
Hold down [DBS/VCR
• Hold down [DBS/VCR
step 5.
3
Press [ENTER].
4
Press number buttons to enter the
manufacturer code.
Examples:
For an Echostar DBS: Press [2], then [1].
For a Sony DBS: Press [2], then [0].
When the manufacturer of your DBS has 2 or
more codes, enter the manufacturer codes in
turn and find the one that operates the DBS
and the remote control properly.
Manufacturer Code
G. I. 01, 02, 03, 04, 05, 06, 07, 08
Echostar 21
Hamlin 15, 16, 17, 18
Jerrold 01, 02, 03, 04, 05, 06, 07, 08
Pioneer 13, 14
RCA 19
Scientific Atlanta 09, 10
Sony 20
Zenith 11, 12
The initial code setting is "01 (G. I.)".
5
Release [DBS/VCR
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
• Manufacturer codes are subject to change
without notice. You may not be able to operate
the DBS produced by the manufacturer.
• After replacing the batteries of the remote
control, set the manufacturer code again.
].
F
] until you finish
F
].
F
54