Operating The Tv Using The Remote Control - JVC EX-A1EB Instructions Manual

This page is for when operating your TV using the
remote control of this product.
Operating the TV using
the remote control
Setting the manufacturer's code
1
Slide the remote control mode
selector to the TV side.
2
Keep pressing down F TV.
NOTE
Keep pressing down F TV until Step 4 is complete.
3
Press ENTER and release.
4
Press number buttons (1-9, 0).
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
If there are more than one manufacturer's codes,
try them in turn and select the one that causes the
product to work properly.
Manufacturer
JVC
Hitachi
Magnavox
Mitsubishi
Panasonic
RCA
NOTE
Manufacturer's codes may be changed without notice.
You may not be able to operate a TV produced by the
manufacturer shown above.
5
Release F TV.
For TV operation
Operate the remote control by pointing it towards
the TV.
Number
buttons
*1 Make sure to slide the remote control mode
selector to the TV side in advance.
NOTE
When the batteries are replaced, perform the
manufacturer's code setting again.
Getting started
Code Manufacturer
01 Samsung
10 Sanyo
02 Sharp
03 Sony
04, 11 Toshiba
05 Zenith
Turn ON/OFF the power.
Change channels.
Adjust volume.
Select channels.
9
100+
*1
Alternates between the
previously selected channel
and the current channel.
Switch TV and video input.
Introduction
Code
12
13
06
07
08
09
7