Advertisement
5 Synchronisation / Pairing / Tahdistus
Installation of the BC 1009 STS into the mounting bracket – The zero
US
of the speed is flashing. To synchronise the speed there are 2 options:
GB
Set off, usually the receiver has paired with the transmitter within
1
3 or 4 wheel turns.
Turn front wheel until the KMH display stops flashing. Removing the
2
BC 1009 STS from the mounting will cut off the connection.
TOO MANy SIGNALS are shown: Extend the distance of all
transmitters and press any button to continue. Pairing begins again.
(If tranmission fails whilst cycling and no longer works, please press the MODE 1 button
for more than 3 sec. to start manual pairing. SyNCH RESET flashes on the display.)
Klem BC 1009 STS fast på holderen. Nullet i hastighedsvisningen
DK
blinker. Til pairing af hastighed FIdes der 2 muligheder:
Kørsel i frihjul, som regel er modtageren pairet med senderen
1
efter 3 til 4 hjulomdrejninger.
Drej forhjulet til KMH-visningen holder op med at blinke.
2
Når BC 1009 STS fjernes fra holderen, afbrydes forbindelsen.
VISNING TOO MANy SIGNALS: Forøg afstanden til andre sendere og
tryk på en vilkårlig knap. Synkroniseringen starter forfra.
(Skulle transmissionen svigte under kørslen og ikke fungere mere, trykker du på
MODE 1-knappen i mere end 3 sek., for at starte en manuel synkronisering. SyNCH
RESET blinker i displayet.)
1009
1
2
13
13
Advertisement
