Mounting And Usage; Slide Table; Rip Fence; Figure 20: Slide Table Controls - PANHANS 680|200 Operating Manual

10

Mounting and Usage

10.1 Slide Table

20
21

Figure 20: Slide table controls

The safety catch (20) is used to move the slide table out of the saw blade area (beyond the stop) during a saw
blade change (for more information see chapter  18.1).

If the machine is not used for a longer period of time, the slide table should be moved to a mid-
dle position. This prevents the rollers from being pressed in.
The slide table must not be locked during a cutting operation.

10.2 Rip Fence

The motorised rip fence is used to feed the workpiece from the rear of the machine (to the right of the saw
blade). The rip fence is already fitted when the sliding table saw is delivered. Only the aluminium profile rail
(16) still has to be inserted.
16
a

Figure 21: Fitting the rip fence

The operation of the rip fence is described in detail in chapter  13. Important: For the operation of the rip
fence, please also observe the hazard warnings in the sections  4.5.3,  4.5.4 and  4.5.5.
BA_PH_680-200_EN_11-22.docx
When the sliding table saw is delivered, the slide table
is already fitted ready for operation.
• Loosen (pull out) the remote locking device (21).
• Move the slide table to the desired position.
• Close (press in) the remote locking device (21).
Set the aluminium profile rail for normal cuts:
17
Set aluminium profile rail for inclined saw blade:
19
b
You may have to move the slide table slightly for-
wards or backwards so that the lock engages cor-
rectly.
•
Push the aluminium profile rail (16) as
far as it will go onto the two fixing
bolts (a) of the holding block. The
cross-section must look as shown in
the photo on the left.
• Fix the aluminium profile rail by
means of the clamp lever (19). The
fence (17) is now ready for use.
• Push the aluminium profile rail (16) onto
the holding block (b) rotated by 90°. The
cross-section must look as shown in the
photo on the left .
• Fix the aluminium profile rail by
means of the clamp lever (17).
Warning! Danger of crushing between
aluminium profile rail (16) and rip fence (17).
35