Mounting And Usage; Slide Table; Rip Fence; Figure 20: Slide Table Controls - PANHANS 680 100 Operating Manual

10

Mounting and Usage

10.1 Slide Table

20
21

Figure 20: Slide table controls

The safety catch (20) is used to move the slide table out of the saw blade area (beyond the stop) during a saw
blade change (for more information see chapter  14.1).

If the machine is not used for a longer period of time, the slide table should be moved to a mid-
dle position. This prevents the rollers from being pressed in.
The slide table must not be locked during a cutting operation.

10.2 Rip Fence

The rip fence is used to feed the workpiece from the rear of the machine (to the right of the saw blade).

Figure 21: Rip fence

The rip fence is already fitted when the sliding table saw is delivered. Only the aluminium profile rail (4) still has
to be inserted (see next page and  Figure 22).
BA_PH_680-100_EN_08-22.docx
When the sizing and trimming circular saw is delivered,
the trolley is already fitted ready for operation.
• Loosen (pull out) the remote locking device (21).
• Move the slide table to the desired position.
• Close (press in) the remote locking device (21).
You may have to move the slide table slightly for-
wards or backwards so that the lock engages cor-
rectly.
34