PANHANS 680|200 Operating Manual page 19

•
If a second person is working at the sliding table saw to remove processed workpieces, this person must
not stand at any other place than at the end of the table extension.
•
Use a ram plate on the slide table when "trimming".
•
Use an aluminium profile rail with a narrow contact edge for cutting narrow and low batten.
•
For cross-cuts use a cross-cut table with cross-cut fence.
•
Use a deflector wedge to cut battens to length.
•
Damaged table inserts must be replaced with new ones.
•
When cutting narrow workpieces, use the push stick.
•
Repairs may only be carried out by qualified personnel with the main switch locked.
•
The machine must be connected to an effective extraction unit with a minimum flow rate of 20 m/s.
•
The machine is equipped with an electric magnetic brake. If this brake no longer brakes within the
prescribed braking time (10 s) despite readjustment, the customer service must be informed.
BA_PH_680-200_EN_11-22.docx
19