Adjusting The Power Tool Prior To Use; Practical Applications - Hitachi C 10FCH2 Handling Instructions Manual

(2) During bevel and compound cutting, attach the dust bag
at a right angle to the base surface as shown in Fig. 3.
Dust bag
Duct
Right angle
CAUTION
Em pty the dust bag frequently to prevent the duct and
the low er guard from becom ing clogged.
Saw dust w ill accum ulate m ore quickly than norm al
during bevel cutting.
6. Installation
Ensure that the m achine is alw ays fixed to bench.
Attach the power tool to a level, horizontal work bench.
Select 8 m m diam eter bolts suitable in length for the
thickness of the w ork bench.
Bolt length should be at least 35 mm plus the thickness
of the w ork bench.
For exam ple, use 8 m m × 60 m m bolts for a 25 m m
thick w ork bench.

ADJUSTING THE POWER TOOL PRIOR TO USE

CAUTION
M ake all necessary adjustm ents before inserting the
plug in the pow er source.
1. Check to see that the low er guard operates smoothly

PRACTICAL APPLICATIONS

WARNING
To avoid personal injury, never rem ove or place a
workpiece on the table while the tool is being operated.
Never place your lim bs inside of the line next to
w arning sign w hile the tool is being operated. This
m ay cause hazardous conditions (see Fig. 4).
Base
Fig. 3
Line
Warning sign
CAUTION
It is dangerous to rem ove or install the w orkpiece
w hile the saw blade is turning.
When sawing, clean off the shavings from the turntable.
If the shavings accum ulate too m uch, the saw blade
from the cutting m aterial w ill be exposed. Never
subject your hand or anything else to go near the
exposed blade.
1. Tightly secure the material by vise assembly to be
cut so that it does not move during cutting
2. Sw itch operation
Pulling the trigger turns the sw itch on. Releasing the
trigger turns the sw itch off.
3. Holder (B), clamp lever adjustment: (Fig. 5)
Attach the included holder (B) in the position as shown
in Fig. 5 and adjust the holder (B) until its bottom
su r f ace co n t act s t h e w o r k b en ch su r f ace. A f t er
adjustm ents, securely tighten the 6m m bolt w ith the
included 10mm box wrench. Loosen the M6 × 20 screw
on the clam p lever and attach to a position w here the
clam p lever can be easily operated.
M 6 × 20 Screw
Clam p lever
6m m Bolt
Holder (B)
Adjust the holder
until its bottom
surface contacts the
w ork bench surface.
Line
Fig. 4
M ove
Fig. 5
5