Using Document Capture Pro Server; Setting Server Mode; Setting Up Airprint - Epson DS-790WN User Manual

Required Settings for Scanning
Messages
Authentication failed.
Check the settings.
Cannot access the product until
processing is complete.

Using Document Capture Pro Server

By using Document Capture Pro Server, you can manage the sorting method, saving format, and forwarding
destination of a scanning result executed from the scanner's control panel. You can call and execute a job
previously registered on the server from the scanner's control panel.
Install it on the server computer.
For more information on Document Capture Pro Server, contact your local Epson office.

Setting Server Mode

To use Document Capture Pro Server, set up as follows.
1. Access Web Config and select the Scan tab > Document Capture Pro.
2. Select Server Mode for Mode.
3. Enter the address of the server with Document Capture Pro Server installed on it for Server Address.
Enter between 2 and 255 characters in either IPv4, IPv6, host name or FQDN format. For FQDN format, you
can use alphanumeric characters in ASCII (0x20-0x7E) and "- " except for at the beginning and end of the
address.
4. Click OK.
The network is re-connected, and then the settings are enabled.

Setting Up AirPrint

Access Web Config, select the Network tab, then select AirPrint Setup.
Items
Bonjour Service Name
Bonjour Location
>

Setting Up AirPrint

This message appears for the following reasons:
❏ User Name and/or Password is incorrect.
❏ If Kerberos Authentication is selected as the Authentication Method, the
time/date may not be configured.
This message appears when the scanner is busy.
Enter a Bonjour service name, using ASCII text (0x20-0x7E) and up to 41
characters.
Enter a description of the scanner's location, using Unicode (UTF-8) text and up to
127 bytes.
145
Explanation
Explanation