Combining With A Presentation System - JVC KY-F1030U Instructions Manual

2. Before shooting (continued)

Combining with a presentation system

The image shot by the KY-F1030 can be passed though a scan rate converter and shown on a
D-ILA presenter or SXGA-compliant monitor.
Connect the power supply
( page E18)
[DC IN]
Mount the lens
( page E17)
1. Connect the KY-F1030's [ANALOG OUT] connector to the scan rate converter's [VIDEO
INPUT] terminal.
2. Connect the AC adapter (AA-P700) to the KY-F1030, and then turn ON the power.
3. Turn ON the other devices.
* Also see the instructions for the scan rate converter to be used.
MEMO
• When connected to the PC through the [IEEE1394] connector, or an RS-232C device is connected to
the [REMOTE] terminal, the auto white balance function of the scan rate converter will be disabled.
• When the shutter speed becomes slower (slower than 1/7.5s), the image may be seen interrupted.
• The image will not freeze even when the scan rate converter's [FREEZE] button is pressed.
• The scan rate converter's [SEND] command is invalid.
E16
AA-P700
AC ADAPTER AA-P700
POWER
ON
OFF
AC adapter
[ANALOG OUT]
[VIDEO INPUT]
terminal
AC
[VIDEO IN]
D-ILA or SXGA-compliant monitor
JVC KM-F700
Scan rate converter