Connecting Through Analog Output Connector - JVC KY-F1030U Instructions Manual

Connecting through analog output connector

The image shot by the KY-F1030 can be shown on the computer's monitor.
Connect the power supply
( page E18)
[DC IN]
1. Connect the KY-F1030's [ANALOG OUT] connector to the PC's capture board.
2. Connect the AC adapter (AA-P700) to the KY-F1030, and then turn ON the power.
3. Turn ON the PC.
* For instructions on how to operate the video capture board or the employed application
software, see the respective instruction manual.
CAUTION
Use a 1/2-inch C-mount microscope adapter compatible with the microscope to be employed.
MEMO
When the shutter speed becomes slower (slower than 1/7.5s), the image may be seen interrupted.
Also, the image will not freeze even when the external trigger switch is pressed.
AA-P700
AC ADAPTER AA-P700
POWER
ON
OFF
AC adapter
[ANALOG OUT]
Microscope
adapter
AC
Video
capture
board
PC
E15