Before You Begin; Using The J-Web Interface - Juniper J4350 Getting Started Manual

J4350 and J6350 Services Router Getting Started Guide
Table 25: Services Router Configuration Interfaces (continued)
Interface Description
J-Web Web browser pages divided into panes in
configuration which you can do any of the following:
editor
Expand the entire configuration
hierarchy and click a configuration
statement to view or edit. The
main pane displays all the options
for the statement, with a text box
for each option.
Paste a complete configuration
hierarchy into a scrollable text
box, or edit individual lines.
Upload or download a complete
configuration.
Roll back to a previous
configuration.
Create or delete a rescue
configuration.
CLI configuration Interface in which you do either of the
editor following:
Type commands on a line and
press Enter to create a hierarchy
of configuration statements.
Create an ASCII text file that
contains the statement hierarchy.
Upload a complete configuration,
or roll back to a previous
configuration.
Create or delete a rescue
configuration.

Before You Begin

Before you start the user interface, you must perform the initial Services Router
configuration described in "Establishing Basic Connectivity" on page 93.
After the initial configuration, you use your username and password, and the
hostname or IP address of the router, to start the user interface.

Using the J-Web Interface

This section contains the following topics:
52
Using the J-Web Interface
Capabilities
Configure all router services:
System parameters
User access and accounting
Interfaces
SNMP network management
Routing options, including
multicast routing
Routing protocols
Routing policies
Secure access
Service interfaces, including
stateful firewalls and virtual
private networks (VPNs)
Traffic engineering, including
Multiprotocol Label Switching
(MPLS) and class-of-service
(CoS) packet prioritization
Chassis properties
Recommendations
Use for complete
configuration if you
are not familiar with
the JUNOS CLI or
prefer a graphical
interface.
Use for complete
configuration if you
know the JUNOS CLI
or prefer a command
interface.