Router Power Requirements; Ac Power, Connection, And Power Cord Specifications - Juniper J4350 Getting Started Manual

J4350 and J6350 Services Router Getting Started Guide

Router Power Requirements

Table 31 lists the AC and DC power system electrical specifications
for J-series Services Routers.
Table 31: AC and DC Power System Electrical Specifications
Item
AC input voltage
AC input line frequency
AC system current rating
DC input voltage
DC system current rating

AC Power, Connection, and Power Cord Specifications

NOTE: The AC power cord for the Services Router is intended for use with the
router only and not for any other use.
Detachable AC power cords, each 2.5 m (approximately 8 ft) long, are supplied
with the Services Router. The appliance coupler at the female end of the cord
inserts into the appliance inlet on the faceplate of the AC power supply. The
coupler is type C19 as described by International Electrotechnical Commission
(IEC) standard 60320. The plug at the male end of the power cord fits into the
power source receptacle that is standard for your geographical location.
NOTE: In North America, AC power cords must not exceed 4.5 m (approximately
14.75 ft) in. length, to comply with National Electrical Code (NEC) Sections 400-8
(NFPA 75, 5-2.2) and 210-52, and Canadian Electrical Code (CEC) Section 4-010(3).
The cords supplied with the router are in compliance.
Table 32 lists power cord specifications and Figure 28 illustrates the plug on
the AC power cord provided for each country or region.
Table 32: AC Power Cord Specifications
Country
Australia
China
76
Power Guidelines, Requirements, and Specifications
Specification
100 to 240 VAC nominal
50 to 60 Hz
J4350 Services Routers: 6 A
J6350 Services Routers: 8 A
–48 to –60 VDC operating range
20 A
Electrical Specifications
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
Plug Standards
AS/NZ 3112–1993
GB2099.1 1996 and GB1002 1996 (CH1-10P)