Powering A Services Router On And Off - Juniper J4350 Getting Started Manual

J4350 and J6350 Services Router Getting Started Guide
4.
Figure 34: Connecting DC Power to the J4350 or J6350 Services Router
Washer Grounding lug

Powering a Services Router On and Off

To power on a Services Router, press the power button. The Routing Engine boots
as the power supply completes its startup sequence. The
startup and remains on steadily when the router is operating normally.
To power off a Services Router, you can shut it down in one of the following ways:
To remove power completely from the router, unplug the AC power cord or switch
off the DC power source. The power button on the Services Router is a standby
power switch. If the router is connected to a power source when you press the
90
Powering a Services Router On and Off
Replace the clear plastic cover over the terminal block.
h.
Verify that the power cables do not block access to router components or
drape where people can trip on them.
Screw with
captive washer
Graceful shutdown—Press and release the power button. The router begins
gracefully shutting down the operating system and then powers itself off.
Immediate shutdown—Press the power button and hold it for more than
5 seconds. The router immediately powers itself off without shutting down the
operating system.
DC Terminal
block
Lug
LED lights during
POWER