Raider RD-EA02 SET User Manual page 16

16 www.raider.bg
your left hand firmly gripping the other.
• Always keep a firm grip with both hands while in operation.
• The post hole digger should be held at a comfortable position with the handle height no higher than
waist level
• The throttle trigger helps control the speed of the auger to suit various ground conditions.
• Keep a comfortable distance between yourself and the drill without overreaching.
• Always pay full attention to your operation serious injuries may result if contact is made with the
rotating auger.
Note: your post hole digger is supplied with a 300mm extension shaft to be used for depper hole
digging do not start digging a hole with the extention attached
The hole should always be started with the auger bit only fitted.
Once the hole is deep enough and the operator handles are at least 300mm below waist level, you may
stop the until and attach the extention shaft between the poer head and the auger for added comfort and deeper
hole depth.
Warning!
Never use the drill with the handles above waist level.
Drilling with the units handles above waist level restricts control and can
cause serious chest injuries if a hard object is struck.
Warning!
Use only original manufacturer's replacement parts, accessories and attachments.
Failure to do so can cause possible injury,poor performance and may void
your warranty.
• You may make adjustments and repairs described here.for other repairs,have the post
hole digger serviced by an authorized service agent.
• Consequences of improper maintenance may include excess carbon deposits resulting in loss of
performance and discharge of black oily residue dripping from the muffler.
• Make sure all guards,deflectors and handles are properly and securely attached to avoid the risk of
personal injury.
Engine
Clean the cylinder fins with compressed air or a brush periodically.Dangerous overheating
of engine may occur due to impurities on the cylinder.
Reduction gearbox
Every 100 working hours change the grease in the reduction gearbox
Lubricant for reduction gearbox
The post hole digger is supplied with TAMOIL TAMLITH GREASE2 greasein the reduction gearbox the
lubrication in the reduction gearbox should be checked periodically. To check the lubrication condition and
level remove the screw under the reduction gearbox.
Cleaning the exhaust port and muffler
Depending on the type of fuel used the type and amount of oil used and/or your operating conditions the
exhaust port and muffler may become blocked with carbon depositsif you notice a power loss with your petrol
powered tool ,a qualifiled service technician will need to remove these deposits tio restore performance.
CLEANING AIR FILTER
A dirty air filter will cause starting difficulty,loss of performance,and shorten the life span
Of the engine.Check the air filter monthly.For best performance,replace the air filter at
Least once a year.
• Loosen the air filter cover by turning the fixing screw counter clockwise.
• Remove the airbox cover and the air filter.
• Clean the foam filter element with warm soap water.Rise and let dry.
NOTE:If the foam filter is damaged, it should be replaced.
• Apply a light coat of engine oil to the foam filter element, then squeeze it out.
• Reinstall the air filter.
NOTE:Make sure the filter is seated properly inside the cover.Installing the filter incorrectly will
allow dirt to enter the engine,causing rapid engine wear.
• Reinstall the airbox cover and tighten fixing screw to secure.