Advertisement
Advertisement
Table of Contents
Related Manuals for Genexis FiberTwist XGS2414
Summary of Contents for Genexis FiberTwist XGS2414
- Page 1 FiberTwist Series Installation Guide...
- Page 2 LED ove view Power Green – system ok Green (blinking) – booting irmware download – power o Uplink Green – link ok Green (blinking) – link establishing – no link Telephone Green – voice se vice registered and ok Green (blinking) –...
- Page 3 Bu ton ove view Po t ove view ON OFF switch Reset Power po t LAN po ts TEL po t bu ton Unlock bu ton Remove FiberTwist XGS – press and hold while wisting counterclockwise LED dim bu ton Dim LEDs –...
- Page 4 Various translations of this document (if available) and additional product information can be . Rotate the Blind Cover or active device counterclockwise till it blocks. found on h tps: genexis.eu product ibe wist downloads . Remove the Blind Cover or active device from the baseplate (FTU Bracket) by pulling Box contents it towards yourself.
- Page 5 Remove dust cap Twist! . Take the FiberTwist XGS out of the box. . Place the FiberTwist XGS on the FTU Bracket as shown in the picture below. . The dust cap is connected to the red string located on the rear of the FiberTwist XGS .
- Page 6 . If required, connect your telephone to the phone po t via an RJ ne work cable. Hereby, Genexis Netherlands B. V . declares that the radio equipment ype FiberTwist XGS . If required, connect your personal devices to the LAN po ts via an RJ ne work cable.
- Page 7 - Copyright © Genexis Netherlands B. V . All rights rese ved. Genexis assumes no responsibili y for any inaccuracies in this document. Genexis rese ves the right to change, modify, transfer, or othe wise revise this publication without notice.
Need help?
Do you have a question about the FiberTwist XGS2414 and is the answer not in the manual?
Questions and answers