Hayward SwimPure Plus Operation And Installation Manual page 2

IMPORTANT SAFETY INSTRUCTIONS
When using this electrical equipment, basic safety precautions
should always be followed, including the following:
READ AND FOLLOW ALL
•
INSTRUCTIONS
•
Use Copper Conductors Only
•
Disconnect all AC power during installation.
•
Warning - To reduce the risk of injury, do not permit
children to use this product unless they are closely
supervised at all times.
•
A green colored terminal marked "Earth Ground" is lo-
cated inside the wiring compartment. To reduce the risk
of electric shock, this terminal must be connected to the
grounding means provided in the electric supply service
panel with a continuous copper wire equivalent in size to
the circuit conductors supplying the equipment.
•
One bonding lug for US models (two for Canadian mod-
els) is provided on the external surface. To reduce the
risk of electric shock, connect the local common bonding
grid in the area of the swimming pool, spa, or hot tub to
these terminals with an insulated or bare copper conduc-
tor not smaller than 8 AWG US / 6 AWG Canada.
•
All field installed metal components such as rails, ladders,
drains, or other similar hardware within 3 meters of the
pool, spa or hot tub shall be bonded to the equipment
grounding bus with copper conductors not smaller than 8
AWG US / 6 AWG Canada.
•
NOTICE TO USERS: This control product is to be used
only in accordance with the directions of this label. It is
an offense under the Pest Control Products Act to use a
control product under unsafe conditions.
SAVE THESE INSTRUCTIONS
•