Siemens CP565AGS0B User Manual And Installation Instructions page 20

en Steam
Open the control panel.
1.
Remove the water tank.
2.
Fill the water tank up to the "MAX" mark.
3.
Insert the full water tank and close the control panel.
4.
11.8 After using steam operation
Moisture will remain in the cooking compartment. Care-
fully wipe out the drip trough and the cooking compart-
ment.
Each time you cook using steam, we recommend that
you run the Rinse cleaning function. Then empty and
dry the water tank and drip tray.
Note: Remove limescale marks with a cloth soaked in
vinegar, then wipe with clean water and dry with a soft
cloth.
Rinsing the appliance
To ensure that your appliance stays clean, you can
pump water through the pipe system. The appliance
then drains the water into the drip tray.
Note: After running the rinse cycle, loosened limescale
particles may be in the collecting container. This is nor-
mal and does not affect operation.
Use the function selector to select ⁠ .
1.
a The display shows the programme duration. You
cannot change the duration.
Open the tank cover.
2.
Remove the drip tray and empty it.
3.
Slide the empty drip tray in fully.
4.
Remove and empty the water tank and drain any re-
5.
sidual water.
Rinse out the water tank thoroughly and fill it with
6.
fresh water.
Slide the water tank in fully.
7.
Close the tank cover.
8.
Press ⁠ .
9.
a The appliance pumps water through the pipes.
a The time remaining counts down in the display.
a An audible signal sounds once this time has
elapsed.
Empty the drip tray.
10.
Emptying the water tank
WARNING ‒ Risk of burns!
The water tank may heat up while the appliance is in
operation.
Wait until the water tank has cooled down from the
▶
previous operation.
Remove the water tank from the tank recess.
▶
ATTENTION!
Cleaning the water tank in the dishwasher will damage
it.
Do not clean the water tank in the dishwasher.
▶
Clean the water tank with a soft cloth and standard
▶
washing-up liquid.
Press on the centre of the tank opening.
1.
a The tank cover hinges upwards.
Pull out the water tank.
2.
Carefully remove the lid of the water tank.
3.
Empty the water tank, clean it with detergent and
4.
then rinse it thoroughly with clean water.
Dry all parts with a soft cloth.
5.
20
Rub the seal on the lid until dry.
6.
Leave the water tank to dry with the lid open.
7.
Place the lid on the water tank and push down on it.
8.
Slide the water tank in fully.
9.
Close the tank cover and briefly press on the centre
10.
of it.
a The tank cover is locked.
Drying the drip trough
WARNING ‒ Risk of burns!
The appliance becomes hot during operation.
Allow the appliance to cool down before cleaning.
▶
Requirement: The cooking compartment has cooled
down.
Open the appliance door.
1.
Open the tank cover.
2.
Remove the water tank and drip tray.
3.
4. Note:
The drip trough is underneath the cooking com-
partment.
Soak up the water in the drip trough
sponge cloth and wipe it carefully.
Heating and drying the cooking compartment
Always dry the cooking compartment after operation to
ensure that no moisture remains.
Allow the appliance to cool down.
1.
Remove the worst of the food residues from the
2.
cooking compartment immediately.
3. Wipe away any moisture from the cooking compart-
ment floor.
Use the function selector to select ⁠ ⁠ .
4.
Press twice.
5.
is highlighted on the display.
a
Use the rotary selector to set a time of 15 minutes.
6.
Press to start.
7.
a The drying process starts and ends after
15 minutes.
Open the appliance door for 1 to 2 minutes to allow
8.
the steam to escape.
Drying the cooking compartment by hand
Always dry the cooking compartment after operation to
ensure that no moisture remains.
Allow the appliance to cool down.
1.
Remove the worst of the food residues from the
2.
cooking compartment.
Dry the cooking compartment with a sponge.
3.
Leave the appliance door open for 1 hour so that
4.
the cooking compartment dries completely.
with a