Tesla MODEL X 2021 Owner's Manual page 46

Child Safety Seats
button, illustrated below. The button is
located on the seat back, directly above its
associated anchor.
Bench Seats
Monopost Seats
In the second row, install LATCH child safety
seats in the outboard seating positions only.
Use only a seat belt retained seat in the
center position.
NOTE: If Model X is equipped with two seats
in the second row, both seats support the use
of LATCH child safety seats.
NOTE: Second row outboard seats support
the use of upper tether straps (see
Upper Tether Straps on page
44
Bench Seats
NOTE: To accommodate large rear-facing
LATCH child safety seats, you may need to
move the seat in the full rearward position,
and move the corresponding front seat
forward to the mid-track position (up to 13
cm forward of the rearmost position), raise
the seat upward (3 cm from its lowest
position), and angle the seat back to 15
degrees (or 10 degrees rearward from its
forward-most position).
Monopost Seats
Attaching
46).
WARNING: Before driving after
installing a child seat in the second
row, ensure that a "seat unlocked"
warning does NOT display on the
touchscreen or instrument panel. This
warning indicates that the seat is
unsafe for an occupant because it was
not returned to its safe, locked
position. If the touchscreen or
instrument panel displays the warning
message, move the seat or backrest
slightly forward or backward until it
locks firmly into position and the
message no longer displays.
WARNING: Do not associate the Easy
Entry setting with the driver's profile
when a child is seated in the second
row. Doing so can cause the driver's
seat to push against the child,
especially when a child is seated in a
forward-facing child seat or booster
seat. Do not rely on Model X to
recognize or accommodate a child
seated in the second row while using
this setting (see Driver Profiles on
page 55).
MODEL X Owner's Manual