Table of Contents
Advertisement
Needle bar pin
7-3)
① Please make sure to check that the position of the needle bar pin might change when carrying machine and
adjusting level. When checking the needle bar pin, first of all, check that the pin is bent. Then put the needle
bar to the lowest stop position by rotating the main shaft near 178 with the main shaft handle, and ascertain
that the needle bar pin is located at the center of the presser foot hole
[CAUTION]
Check the regular position of the needle bar pin at the first and the last of all heads.
② If the needle bar pin is off the regular position, loosen the bracket clamping screws(2 parts) like a [Figure 7-5]
and adjust the needle bar pin to the regular position by moving the head.
Bracket screws
L-wrench
Needle plate
Head
Needle plate
7-3
[Fig.7-5]
Advertisement
Table of Contents
