Maintenance; Environmental Protection - Worx WG252E Original Instructions Manual

Charging the battery pack
More details can be found in charger's
manual
ASSEMBLY
Attaching and releasing the extension
pole
Attaching and adjusting the shoulder
strap
It is recommended to always attach the
shoulder strap when using the tool.
Adjust the shoulder strap to obtain a
comfortable working position.
IMPORTANT: Never attach the strap
diagonally across your shoulder and
your breast, but rather place it on one
of your shoulders. In this way you can
remove the tool quickly from your body
in case of danger.
Extending the inner pole
Rotating rear handle
NOTE: The cutting angle can be
adjusted between 0
WARNING: Always make sure that
the handle is locked in the desired
position before operation. Do not rotate
the handle when the trimmer is being
operated.
12
Adjusting the head angle
WARNING: Failure to properly
secure the trimmer head may result
in personal injury and/or property
damage.
OPERATION
Removing the blade sheath
Starting and Stopping
Top cutting
WARNING: If any parts are missing,
damaged or broken, do not operate
your hedge trimmer until all damaged
parts have been replaced or repaired.
Failure to do so could result in serious
personal injury.
Side cutting
WARNING: Stop operating the
trimmer before rotating the handle.
Lubricating the cutting blade
NOTE: It is important to use only the
recommended standard lubricating oil
(WD-40) to avoid damage to the blade.
20V Cordless Pole Hedge Trimmer
See Fig.A4
See Fig.
B1, B2
See Fig. C
See Fig. D
-90 left or right.
0 0
See Fig. E
See Fig. F
See Fig. G
See Fig. H
See Fig. I1
See Fig. I2
See Fig. J
HOW TO USE YOUR HEDGE
TRIMMER
Before cutting an area, inspect it first and remove
any foreign objects that could become thrown or
entangled in the blades.
Always hold the trimmer with both hands and with
the blade away from you before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
blade.
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer.
Release the two Switch Levers before attempting to
clear jammed debris from the cutting blades.
Wear gloves when trimming thorny or prickly growth.
Do not attempt to cut stems that are too thick for the
cutting blade.
Top cutting
Use a wide sweeping motion. A slight downward tilt
of the cutting blades in the direction of motion gives
the best cutting results.
Side cutting
When trimming the sides of the hedge, begin at
the bottom and cut upwards, tapering the hedge
inward at the top. This shape will expose more of
the hedge, resulting in a more uniformed growth.

MAINTENANCE

Remove the battery from hedge trimmer
before carrying out any adjustment, servicing
or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working
controls free of dust.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
EN