iCoolsport 2 Series Owner's Manual page 21

CURRENT POOL
PROGRESS BAR
5. Progress Bar
A PROGRESS BAR will appear along the bottom of the screen
to inform you of the start up progress. If the systems detects
a safety issue or a lack of water flow, it will stop the start up
sequence and the screen will inform you of the reason.
The Start Up Sequence procedure will undergo the following
steps:
1
Starting Water Flow: your machine will automatically start
the water circulation pump and the pump will start flowing in
your pool. If everything runs correctly, it will say " Water flow
started"
2 Starting System: after a few seconds, the refrigeration
compressor motor will start. If everything runs correctly, it will
say "System started"
3 Introducing Air Flow: after a few more seconds, the main
airflow fan will start.
4
Starting System Check: to finish, your machine will run a full
system check to make sure everything is running correctly.
If the start up sequence has been successful, the
screen will say "SYSTEM STARTED"
In this case, everything has tested correctly and the machine is
now chilling to the set temperature.
That's it!
Your machine will now do all the rest and there is nothing else
for you to do. It has been designed to always be on and ready
to use.
Your MiPod has been manufactured using quality components
from the world's leading manufacturers and is therefore
capable of continuous 24/7 operation.
If you wish to have your pool available at your desired
temperature at any time of the day or night then you can leave
it running continuously at very low operating cost. The MiPod
is so efficient that if you use it every day, it will cost less to
operate if you leave it running continuously.
A sophisticated power management system is included
that will automatically use several sensors to evaluate all
conditions and adjust to use the lowest power possible to
maintain your set temperature.
Because of the extremely effective insulation it will only need
to operate for a short time each day to maintain your desired
temperature and always be ready for use.
START UP SEQUENCE ERROR
If the start up sequence fails, please check that all 4
steps of the procedure are running correctly.
1 If the water does not flow steadily when you first
start up, this is usually due to air being trapped in the
pipes or not sufficient water in your pool. Your machine
will attempt to clear any air trapped in the pipes
automatically 3 times. If not successful, the screen will
let you know there's a water flow issue.
2
Listen carefully to the start up sequence and wait to
hear the refrigeration motor sound.
3
Make sure you can feel airflow coming from the
back panel of your machine
When contacting iCool Support, please send pitures
and a short video of the screen as it starts up. This will
help engineers to better determine the problem and
give you the best advice.
21