Table of Contents
Advertisement
User Interface
The all new modern user interface has been completely redesigned to provide completely automatic
start up and operation. It has an intelligent water flow correction and will attempt to correct issues
automatically.
1. Software Load
Once you have switched on the MAIN POWER, the touch
screen will be blank for a few seconds. A few seconds later,
the iCoolsport logo will appear.
This will continue until your machine has loaded its operating
software and run a full system check. This can sometime take
up to a minute.
DO NOT TOUCH THE SCREEN DURING THIS SELF TEST
PROCEDURE.
2. Welcome Screen
A welcome screen movie of ice and snow indicates that the
machine has loaded the latest software and all safety checks
have been completed successfully.
TOUCH the screen anywhere and the Main Operating Screen
will appear.
20
3. Initial Connection
Your touch screen will usually connect to the MiPod main
operating page automatically, however in some circumstances
this page may appear because it has not yet recognized your
MiPod. If this happens, after a short time a small blue square
appears at the top left of the screen (as shown below). Simply
tap anywhere on this small blue square to connect manually.
Do not touch anything in the narrow blue band on the left
hand side, this is for service settings only.
4. Starting Up
To start the unit, simply set the temperature you require by
-
+
repeatedly clicking
or
and hit the "Set" button to lock in
your desired target temperature. Then press START and your unit
will begin its fully automatic START UP SEQUENCE PROCEDURE.
Please note: MiPod Chills will automatically cool water down
(max to 5ºC); MiPod Hots will heat water up to max. 40ºC,
MiPod Dual Temps will automatically select if it needs to chill
or heat to achieve selected temperature (range from 5ºC to
40ºC).
Advertisement
Table of Contents
