Konica Minolta bizhub C750i Installation Manual page 6

7. Unpacking the main body
Whether the slope is supplied with the main body or
not depends on your marketing areas. Follow the
notes below.
Note:
• When the slope is supplied with the main
body, perform the procedures in "How to use
the supplied slope}
• When the slope is not supplied with the main
body, perform the procedures in "How to use
the jig slope} E-8".
■ How to use the supplied slope
(1) Open the shipping box and remove the pack-
aging materials.
Note:
The supplied slope removed in this step is for
later use.
E-6".
Supplied slope
(2) Hold onto the handle of the main body and tilt
the main body to the right and left. Under this
condition, remove the fixing materials.
(3) Pull out the tray 1 from the main body and re-
move the accessory parts.
Note:
The nails removed in this step are used later to
hold the slope in place.
Nail
E-6