Led; Installation; Hdd/Ssd Installation - JHCTech KMDA-2702 User Manual

User's Manual

2.4.16 LED

There are 1*Power on LED, 1*HDD Run LED, 3*CPU temperature class LEDS on the front. CPU
temperature class LEDs(Green(≤85℃)/Yellow(≥86℃and≤95℃)/Red(≥96℃). Users can monitor the
working state of the CPU according to the display of the LED.

2.5 Installation

2.5.1 HDD/SSD Installation

Step 1: Unscrew 4 screws on the underside, remove the bottom bracket.
Step 2: Unscrew 2 screws on the front/rear panel.
Step 3: Unscrew the spring pad and nut of the DC-IN on the front panel, Unscrew 6 serial copper columns
and 5 screws on the front panel.
Step 4: remove the front panel and the bottom cover.
Step 5: Put the HDD/SSD in the drive bay and screw 4 screws.
Step 6: Pull the drive bay onto the bottom cover and screw 4 screws.
Step 7: Using the SATA cable connect the HDD/SSD with the mother board.
Step 8: Close the bottom cover back to the chassis. install the front panel and screw 2 screws on the
front/rear panel.
Step 9: Screw 5 screws and 6 serial copper columns on the front panel. Lock the spring pad and nut of the
DC-IN on the front panel.
Step 10: Install the bottom bracket, screw 4 screws.
Figure 2.27
23