Advertisement
8
1
Step 1
Foot and Leg Sockets
12) 5/8 x 1.5 Hex Bolts
Step 5
Foward H-Frame
2) 3/4 x 6.5 Bolts
2) 3/4 Washers
2) 3/4 Nylock Nuts
Rear H-frame
ASSEMBLY IN STRUCTIONS
7
3
4
Step 2
Forward X-Member
8) 3/8 x 1.0 Bolts
8) 3/8 Nylock Nuts
8) 3/8 Washers
Step 6
Cylinder
2) 3/4 x 3.5 Clevis Pins
2)
Hair pins for Clevis pins
No te:
Use off-center position for cylinder if
boat is equipped with skegs
Note:
Place hoses at rear of
lift facing toward pump
Assembly Instructions are continued on page 4
Note:
6
Install bunks with decals
toward outside of lift
5
Step 3
Aft X-Member
8) 3/8 x 1.0 Bolts
8) 3/8 Nylock Nuts
8) 3/8 Washers
Step 7
Step 8
Bunks
Bunks
4) 3/8 x 1.25 Bolts
4) 3/4 x 4.0 Bolts
4) 3/4 Washers
4) 3/8 Washers
4) 3/8 Nylock Nuts
4) 3/4 Nuts
decals
Note:
Point bolts toward center of lift,
opposite decals - then tighten all
bunk clip carriage bolts
Having Trouble?
Call Basta Marine at
1-866-GOBASTA or contact
your local dealer for help
with assembly and installation.
2
Step 4
Aft H-Frame
2) 3/4 x 6.5 Bolts
2) 3/4 Washers
2) 3/4 Nylock Nuts
3
Advertisement
