Upgrading The Software To Version 2.7.1 - Polycom RPX HD 400 Series Release Notes

Upgrading the Software to Version 2.7.1

If the software at the RPX HD site is being upgraded to version 2.7.1 from an earlier version, the
installer must follow these configuration procedures:
1. Upgrade the Delta projector firmware if necessary.
NOTE
2. Upgrade the HDX software.
3. Configure the control system.
4. Install and use the Telepresence Tool.
5. Configure the Immersive Telepresence features.
6. Align and calibrate the projectors (if you upgraded the projector firmware).
7. Configure, align, and match the cameras (if you upgraded the projector firmware).
The steps above are described in the Polycom RealPresence Experience (RPX) HD 400 Series Installation
Guide, Version 2.7.1 or the Polycom RealPresence Experience (RPX) HD 200 Series Installation Guide,
Version 2.7.1 as well as the Polycom Immersive Telepresence (ITP) Administrator's Guide.
Important Note: If your RPX HD system was installed after April 30, 2010 and you wish to upgrade
from version 2.6 to version 2.7.1 software, you may need to obtain a new 1080p software license (part
number 5150-26946-001) from Polycom. Please contact Polycom Customer Support at
http://support.polycom.com
If you are upgrading the software to version 2.7.1 and your system
has Delta projectors, you must ensure that the Delta projector
firmware is at the correct version listed in the previous section. This
may require you to upgrade the projector firmware. The firmware
upgrade must be performed onsite by a trained installer.
for more information.
3