Table of Contents
Advertisement
Product Manual Thrii-Tap+ D Hand Wash
Dryer
Note: All cleaning chemicals should be used exactly as indicated by the
manufacturer's instructions (including appropriate dilution).
Note: Any chemicals intended for use should first be tested on an
inconspicuous area to check suitability.
Chemical guidelines
Most professional cleaning chemicals suitable for stainless steel can be used.
The following are some that are harmful to the Thrii Tap+.
• Alcohol-acid mixes
• Alcohol Solvent /oil-based mixes
• Quaternary ammonium
• Alkali-bleach mixes
• Foaming ingredients
• Bleach or abrasive cleaners
Contact us for more information:
01722 744594
www.wallgate.com.
9.2. Routine Maintenance
The following routine regular maintenance in between service intervals will help to
prevent premature parts failure:
• Flush the soap pump system with warm water to remove congealed soap within
the pump, tube & soap nozzle.
• Clean the external surfaces of the soap nozzle to remove congealed soap.
• De-scale the water spray nozzle.
• Clean the lens on the infra-red hand sensor.
• Clean the waste outlets on the basin bowl and flush out / clean the waste sump.
• Clean & de-scale the tap head (the water outlet nozzle can be replaced if
necessary.
• Check the control module functions of soap, water and dryer dispensing are
operating correctly. Any malfunction must be reported so that service repair work
can be arranged to avoid further potential damage to the module.
• Clean the solenoid valve inlet filter and diaphragm.
• Inspect external air filter on the bottom of the control module for dust and debris,
clean or replace the filter mesh if blocked.
Warning! Switch OFF the electrical power to the module in the event of a
serious fault or if the module fails to operate.
Revision 2
34
Advertisement
Table of Contents
