Table of Contents
Advertisement
Product Manual Thrii-Tap+ D Hand Wash
Dryer
7. Installing the Support Frame, Water, Waste and
Electrical Connections
7.1. Pre-installation Guidelines
Warning! This appliance is not to be installed in locations where freezing can
occur.
We recommend that adequate frost protection is provided in the building to ensure
freezing does not occur.
Note: When selecting a mounting position, it is important to consider the
suitability of the wall construction. It must support the weight of the assembled
unit as shown in Fig.6.
Note: Water and mains power are located on top of the control module
Make an accurate opening in the deck surface according to the dimensions shown
inFig.4noting the appropriate distance from the basin.
Warning! All electrical work must be carried out by a qualified electrician and
should be installed in accordance with the current Nationally Approved
Regulation
The installer must:
• Provide an electrical supply of 220–240VAC 50/60Hz with a socket suitable for
the installation environment. For installations into rooms with baths or showers
the control module is to be installed into a switched fused spur. The fused spur
must be a 13Amp, double pole connection point that is local to the module (the
contact separation of the fused spur switch should be at least 3mm). Earth
bonding for this type of module must comply with the nationally approved
regulations.
Warning! The socket / switched fused spur MUST be easliy accessible in case
of emergency
• Provide a water supply mounted a short distance from the module. Terminate the
water supply with a suitable isolating tap. For optimum operation, a dynamic
water flow pressure of between 1 & 3 bar is required.
Note: Request advice from Wallgate before you connect the control module to
a gravity-fed water supply.
Revision 2
12
Advertisement
Table of Contents
