Table of Contents
Advertisement
Product Manual Thrii-Tap+ D Hand Wash
Dryer
8.2. Advanced Adjustment
The unit is supplied with factory settings as shown in Fig. 21 below. Further
adjustments can be made to the configuration of the water, soap, air operations, the
cycle sequence and the IR sensor trigger or activation length.
Warning! Incorrect alterations to the default hand wash settings may result in
malfunctions or possible unit damage. If in any doubt, contact "Wallgate after-
sales service" for advice & information.
Description
Soap dosage liquid/foam
Delay Time
Water Time
Dryer Time
End of cycle delay Time
Water cycle auto cancel ¹
Hand drier auto cancel ¹
IR sensor trigger length
Set to zero to disable the auto cancel function.
Figure 21: Settings table.
Figure. 21 F-Functions table for Water, Dryer and Soap times (shown in order of
operation) & auto cancel function.
1. To change the settings, you will need to enter the programming mode,
press and hold 'MENU' and 'ENTER' buttons simultaneously for 5 seconds
see figure 19. After this period, the display will read 'F 01'.
2. With 'F' menu item displayed (as shown in the Fig.19), momentarily
pressing the 'UP' and 'DOWN' buttons will move up and down the menu
selection.
3. When the desired menu item is selected, press the 'ENTER' button to
confirm. The display will show the current value, flashing, for that menu
item.
4. To adjust the flashing value, press the up or down button as required.
5. To save the required value, press the 'ENTER' button. This action saves
the value and switches the display back to the selected menu item.
Factory
Setting range
Settings
Min.
Max
0.4 sec
0.1
10
1 sec
1
10
10 sec
1
100
45 sec
1
100
3 sec
1
10
0 sec
0
10
2 sec
0
10
100
1
250
Revision 2
Function
Increment
0.1
F 8
0.1
F 10
1
F 04
1
F 06
0.1
F 11
1
F149
1
F71
1
F68
31
Advertisement
Table of Contents
