Table of Contents
Advertisement
Product Manual Thrii-Tap+ D Hand Wash
Dryer
8.1.2. Dryer Operation
There are 3 dryer speed settings. The control to adjust the speed is located on the
control module LCD control panel. To change the speed, the Control Module must be
powered up (The fan does not need to be operating). On the LCD control, there is a
small push button labelled 'Fan Speed' see figure 19. Press and hold this button to
select the desired setting, this is confirmed by a five-second fan cycle. (It should be
noted that lowering the fan speed will take longer to dry the hands).
8.1.3. Air Heater Operation
The Thrii-Tap+ hand dryer has an air heater installed to ensure the user dries their
hands in comfortable, high velocity air. This can be turned on or off on the LCD
control panel shown in figure 19. Press and hold button 10 for 2 seconds to switch
between the two settings. To show the setting has been confirmed the correct LED
will illuminate.
8.1.4. Hygiene Purge
The Thrii Tap+ handwash unit is factory set to run an automatic 1-minute water cycle,
hygiene purge at 00:00 every day. This is the default setting; final settings are the
responsibility of the customer and must be based on the specific requirements of
their water system. To adjust the settings, follow the instructions in the advanced
adjustment section 8.2.1.
Revision 2
30
Advertisement
Table of Contents
