Every effort has been made to supply information within this manual which is correct. Wallgate Limited will not be liable for any damage or loss that arises if the person installing, operating or maintaining the unit has not read or not complied with the manual In any event, and without prejudice to any warranties in Wallgate Limited’s terms and...
Product Manual PSH-23 2. Conventions Certain conventions are used in this manual to make it easier to read and understand. They are given in the sections below. 2.1. Warning A warning with white text on a red background is used to give information about hazards that can cause injury or death.
The PSH is used in police holding cells as an extremely safe in-cell hand wash solution. The PSH-23 is an anti-ligature, anti-vandal solid surface recessed basin operated with a piezoelectric touch button to provide handwashing with a cold or pre- mixed supply.
(typically 850mm gives a height of 1m to the basin opening lower edge). 2. The electronic control unit (Sold as a separate option, various models are available, contact Wallgate sales office) must be permanently fixed to the wall, and positioned above all water pipes and fittings as shown on the drawing INS_PSH_23 (Figure 1).
Product Manual PSH-23 4. The basin has one water outlet nozzle which may be connected to either hot or cold water supplies as required, for which the pressure should be between 1 and 3 Bar (100kPa – 400kPa) (Dynamic). The unit is fitted with a solenoid valve for operating the water.
Product Manual PSH-23 5.4. Water Supply Connection NOTE: Prior to proceeding with the following instructions, the water supply pipes must be flushed through, to remove any debris and air locks that may result in blockages and product failure. 1. The hand wash requires a water supply connection to the inlet. ø15mm male connection is required.
Product Manual PSH-23 5.6. Electrical supply connection NOTE: The electrical connections must be carried out by a qualified electrical engineer in accordance with nationally approved IEE Regulations. 1. Complete all electrical testing of the installation before proceeding any further. 2. Refer to the product manual for the model of electronic control unit being installed for full installation and operating instructions.
2014/30/EU directives. 8. Use and Maintenance Instructions The PSH-23 water dispenser has been designed and manufactured from quality materials. If these instructions are followed, the unit will give reliable efficient service. The installer must pass these instructions to the customer.
8.2. Maintenance • Wallgate operates a comprehensive service package, details of which can be obtained from our “After Sales Service Department”. A full spare parts facility is also available. • General wear will mainly affect the components in contact with the water dispensing and the basin waste outlet.
BRUSH01 Waste grille cleaning brush. 9. Related Documentation The PSH-23 can be used with any of the following control units: • WDC100. For more information on this control unit, refer to the WDC100 product manual. • WDC200. For more information on this control unit, refer to the WDC200 product manual.