Table of Contents
Advertisement
1.5. Quick Response— Alarm Silence
After you see a FIRE alarm, find the cause of the alarm. Then respond in accordance with your facility' s emergency
response guidelines. Finally, SILENCE the signalling appliances, as described below.
PRESS PANEL SILENCE
TO SILENCE BUZZER
POWER
YELLOW LED WILL
LIGHT WHEN ALARM
SILENCE IS ACTI-
VATED
LAMP
TEST
Figure 1--8 Alarm Silence. Turn keyswitch to " Enable,"press ALARM SILENCE.
What you do
Insert key into keyswitch. Turn to the Enable
position (12 o" clock position) .
Press
ALARM SILENCE
Press
and
to see a list of
t
s
alarms and other system activities.
ACCEPT alarms. (See Section 1.4., page 7)
After alarm cause has been found and
remedied, RESET the system. (See Section
1.6., page 9.)
NOTE:
ALARM
SILENCE
AUTOCALL TFX Fire Control System Operator' s Manual
PANEL SILENCE
FIRE
TROUBLE
ALARM SILENCE
SUPERVISORY
SYSTEM RESET
DRILL
Key
ENABLE
OFF
Allows access to touchpad functions.
1
alarm; change from pulsing to off for trouble or supervisory alarm.
alarm; change from pulsing to off for trouble or supervisory alarm.
2
3
4
5
Fire alarm messages will be displayed first. Trouble conditions will
also be displayed, but only after the last fire event has been
viewed.
(See Section 1.4., page 7 .)
(See Section 1.6., page 9 )
only silences the notification appliances and does not reset the alarm outputs.
8
firealarmresources.com
OPERATOR DISPLAY MODULE
FIRE ALARM
Main Workshop
Zone 2 A48 001
1
2
3
4
5
6
7
8
9
0
What happens
Buzzer will change from constant to pulsing tone for
Fire Zone red LED will light continuously.
Bells, horns, etc. (signalling appliances) will be silenced.
All alarm outputs will remain active.
Display will continue to display alarm information.
Y
B
DELETE ENTER
NO YES
FAST
ACCESS
QUIT
Advertisement
Table of Contents
