Wiper Blades And Washer Jets - Tesla MODEL X 2015 Owner's Manual

Checking and Cleaning Wiper
Blades
Periodically clean the edge of the wiper blades and
check the rubber for cracks, splits, and roughness. If
damaged, replace the blade immediately to prevent
damage to the glass and improve visibility.
Contaminants on the windshield, or on the wiper blades,
can reduce the effectiveness of the wipers.
Contaminants include ice, wax spray from car washes,
washer fluid with bug and/or water repellent, bird
droppings, tree sap, and other organic substances.
Follow these guidelines for cleaning:
• Clean the windshield and wiper blades using washer
fluid, isopropyl (rubbing) alcohol, or non-abrasive
glass cleaner approved for use on automotive glass
and rubber. Inappropriate products can cause
damage or smears, and create glare on the
windshield.
• Lift the wiper arm a short distance away from the
windshield, just far enough to access the wiper blade.
Do not lift a wiper arm beyond its intended position.
If the wipers remain ineffective after cleaning, replace
the wiper blades.
Replacing Wiper Blades
For optimum performance, replace the wiper blades at
least once a year.
NOTE: Only install replacement blades that are identical
to the original blades. Using inappropriate blades can
damage the wiper system and windshield.
NOTE: The wiper washing system is an integrated part of
the wiper blades on Model X
To replace the wiper blades:
1. Shift into Park and turn off the wipers.
2. Touch Controls > Service > Wiper Service Mode > ON
to move the wipers to the service position.
3. Lift the wiper arm a short distance away from the
windshield, just far enough to access the wiper blade.
CAUTION: Wiper blades do not lock into a lifted
position. Do not lift a wiper arm beyond its
intended position.
4. Squeeze the two tabs to release the wiper blade from
the wiper arm.
CAUTION: The wiper blade is still connected to
the washer hose and cannot be removed yet.
Maintenance

Wiper Blades and Washer Jets

5. Place a towel between the wiper arm and windshield
to avoid scratching or cracking the windshield.
6. Disconnect the washer hose from the wiper blade,
taking care to avoid spilling any washer fluid.
7. Hold the wiper arm and press the locking tab while
sliding the blade down the arm.
8. Fully insert the washer hose onto the nipple of the
new wiper blade.
9. Align the new wiper blade on the wiper arm and slide
it toward the end of the wiper arm until it locks into
place.
10. Turn Wiper Service Mode off to return the wipers to
their normal position.
Cleaning Washer Jets
If a windshield washer becomes blocked, use a thin
strand of wire to clear any blockages from the nozzles.
195